With your OK, HeyCatch and PostHog use cookies to see how you use the site, and link it to your account if you sign in. Cookie Policy

What we collect

With your OK, our analytics providers HeyCatch and PostHog use cookies on our website and sign-in pages to see which pages you visit and where you came from, what you click, your browser and device, and your IP address (for rough location). If you then sign in, we link this to your account, along with a few milestones in the app, such as finishing setup, your first pantry item or recipe, and starting or ending a subscription. These analytics stay off on these pages unless you allow them.

Melt and pour soap: scent, colour, and fixing the usual problems

Hi, I'm Ellie. Melt and pour is where a lot of soap makers start, and for good reason: the base is already soap, so you skip the hardest part. You melt it, add your scent and colour, and pour. Here's how I keep a batch looking and smelling the way you planned.

Pick your base first

The base decides the lather, how hard the bar is, how strongly it carries scent, and how it holds detail, so choose it before anything else. Every melt and pour base is already soap; you're choosing a finished blend, not building one.

BaseGood forWatch for
Clear glycerinEmbeds, bright colours, strong scentSweats in humid rooms
White or sheaCreamy latherMutes colours
Goat's milkA creamy feel customers ask for by nameScorches if it gets too hot
HoneyWarm tonesA softer bar; darkens if overheated
Butter basesA harder, richer barCosts more per batch

Test a small batch of a new base before a full run, and note what you did so the next batch matches.

Scent

I keep fragrance in a melt and pour bar to 3% of the base weight. Weigh the base, then weigh the oil against it rather than counting drops. If your fragrance oil’s own certificate allows less than that, I use the lower number. Your supplier publishes that certificate, and I read it from the fragrance on your shelf.

Temperature

Melt the base gently to about 130–140°F. Short bursts in the microwave or a gentle water bath both work; boiling the base makes it thick and rubbery. Let it cool to about 120–130°F before you stir in scent and colour, so the fragrance doesn’t flash off.

Colour

Micas and pigments made for soap disperse best when you mix them into a little of the melted base (or a splash of glycerin) first, then stir that into the rest. Start with less than you think you need: you can always add more, and a heavy hand can colour the lather.

Layers that stay together

Layering is where melt and pour shines. Let the first layer set until its surface firms up, give it a spritz of rubbing alcohol, then pour the next layer a little cooler than the first. The alcohol breaks the surface tension so the layers bond instead of splitting when you cut the bar. For thin accent layers and embeds, choose micas and pigments that don't bleed, since many liquid dyes travel into the next layer. Keep every layer within the scent limit above too: an over-scented layer weeps into its neighbours.

Fixing the usual problems

  • Bubbles on top. A light spritz of rubbing alcohol over a freshly poured bar pops them. Rubbing alcohol is flammable, so keep it away from the stove and any open flame.
  • Beads of moisture ("sweating"). Glycerin in the base pulls water from the air. Wrap finished bars snugly once they've set, and store them somewhere dry.
  • A soft bar. It's usually too much fragrance or additive for the base. Check the scent against the limit above next time.

No cure, but give it time

Because the base is already soap, there's no cure to wait out. Let the bars harden fully and let any surface moisture dry before you wrap and label them.

Let me plan the batch

Tell me the base you have, the mold and the scent, and I'll weigh out the fragrance and colour for your exact batch and write the steps in order.